Registration Of Remote Control; Remote Control Operation - Worcester GREENSPRING CWi47 Installation And Operating Instructions Manual

COMMISSIONING
B Press one time to access the program P2. In the
LCD display is visible the attributed value (factory
value: 12).
B Press or to choose the fan speed suitable
+
with your installation, see tab. 26 for concentric
conducts Ø 80/125 mm.
B Press and hold (± 5 sec.) "Program" button
the display flashes.
Selected value is memorized.
FAN SPEED FOR CONCENTRIC FLUE Ø80/125 MM
Mode Flue length
P2 From 1 m until 3 m
from 3.1 m until 7 m
from 7.1m until 8 m
Tab. 26
1) Total flue lengths of table 24 do not count with the first
elbow and the horizontal flue kit.
Do not set P2 to greater then 14.
9.8 REGISTRATION OF REMOTE
CONTROL
Only a qualified technician is allowed to install the
additional PCB that is supplied with the remote (part
number: 7709 003 736). Registration can only be made
after installation on the PCB.
The registration of the remote control must be done near
the appliance.
Turn off the hot water tap.
Turn OFF the appliance (Fig. 8, pos.1).
B Press and hold the programming button (Fig. 8,
pos.3), press ON/OFF button (Fig. 8, pos. 1) to
connect the appliance.
Release programming button only when LCD displays
"188".
The LCD displays the signal "P2".
B Press button , until it displays the signal "P3".
B Press programming button again for about 1 second.
LCD panel displays one number and one rotating
digit.
The number represents the remote control which is to
be registered, the first remote control will be
registered with number "0", the second with number
"1" and so on.
B Test the remote control in front of the electronic box
by simultaneously pressing the
buttons.
44
until
1)
Fan speed
12
13
14
and control
NOTE: up to 6 remote controls can be
connected to a single water heater, each
with a range distance of 30m.
Fig. 61 Activate new control
B Press both buttons on the remote control until the
LCD panel stops flashing and shows the indication
"00".
B Press ON/OFF button (
the appliance.
Remote control is now activated.
Press the ON/OFF button to turn ON the
remote control and it's ready to work.
9.9

REMOTE CONTROL OPERATION

This appliance fulfills European directive requirements
1999/5/CEE (R&TTE) and corresponds to the
specifications described in the corresponding CE
certificate of proof.
B Press buttons and
requested temperature.
Fig. 62 Remote control (temperature selection)
6 720 646 322 (2012/05)
Fig. 8, pos. 1) to disconnect
in order to reach