Troubleshooting - Schwinn IC2 Indoor Cycling Bike Assembly Manual

Condition/Problem
Console will not power up/turn
on/start
Speed displayed is not
accurate
Speed displayed is always "0"/
stuck in Pause mode
No speed/RPM reading
Console shuts off (enters sleep
mode) while in use
Things to Check
Batteries
Display set to wrong unit of
measure. (English/Metric)
Data cable
Check data cable integrity
Check data cable
connections
Check magnet position (re-
quires chain guard door
removal)
Check RPM Sensor (requires
chain guard door removal)
Check data cable integrity
Check data cable
connections/orientation
Check magnet position (re-
quires chain guard door
removal)
Check RPM Sensor

TROUBLESHOOTINg

Make sure batteries are
installed correctly. If batteries
are correctly installed, replace
with a set of new batteries.
Change display units.
Make sure the data cable is
connected to the back of the
Console and the main frame
assembly.
All wires in cable should be
intact. If any are cut or crimped,
replace cable.
Be sure cable is connected
securely.
Magnet should be in place on
sprocket drive.
RPM sensor should be aligned
with magnet and connected
to data cable. Realign sensor
if necessary. Replace if there is
any damage to the sensor or
the connecting wire.
All wires in the cable should be
intact. If any are cut or crimped,
replace cable.
Be sure cable is connected
securely and oriented properly.
Magnet should be in place on
sprocket drive.
Contact Customer Care for
further assistance.
Solution
25