Troubleshooting - Schwinn IC7 Service Manual

Troubleshooting

Condition/Problem
Console will not power up/
turn on/start
Speed displayed is not
accurate
Speed displayed is always
"0"/stuck in Pause mode
No Speed/RPM reading
Console display is dim
Unit operates but
Telemetric Heart Rate not
displayed
sleep mode) while in use
Check batteries.
Check data cable integrity
Check data cable
connections/orientation
Check console display for
damage
Check Speed Sensor
Magnet position
Data cable
Speed Sensor
Check data cable integrity
Check data cable
connections/orientation
Check Speed Sensor
Magnet position
Check Speed Sensor
Assembly
Batteries
Chest Strap (optional)
Chest Strap Batteries
Interference
Replace Chest Strap
Replace Console
Check data cable integrity
Check data cable
connections/orientation
Check batteries.
Check Speed Sensor
Magnet position
Check Speed Sensor
Assembly
Make sure batteries are installed correctly. If batteries are
correctly installed, replace with a set of new batteries.
All wires in cable should be intact. If any are visibly crimped or
cut, replace cable.
Make sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Check for visual sign that console display is cracked or
otherwise damaged. Replace Console if damaged.
If the above steps do not resolve the problem, contact
Customer Care for further assistance.
Speed Sensor Magnet should be in place on Flywheel.
Make sure the data cable is connected to the Console and the
main frame assembly.
Make sure the RPM Sensor Magnet and the RPM Sensor are
in place.
All wires in cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Speed Sensor Magnet should be in place on Flywheel.
Speed Sensor Assembly should be aligned with magnet and
connected to data cable. Realign sensor if necessary. Replace
if there is any damage to the sensor or the connecting wire.
Replace batteries
Strap should be "POLAR
sure strap is directly against skin and contact area is wet.
If strap has replaceable batteries, install new batteries.
Try moving unit away from sources of interference (TV, Micro-
wave, etc).
If interference is eliminated and HR does not function, replace
strap.
If HR still does not function, replace Console.
All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Make sure batteries are installed correctly. If batteries are
correctly installed, replace with a set of new batteries.
Speed Sensor Magnet should be in place on Flywheel.
Speed Sensor Assembly should be aligned with magnet and
connected to data cable. Realign sensor if necessary. Replace
if there is any damage to the sensor or the connecting wire.
Contact Customer Care for further assistance.
6
Solution
" compatible and uncoded. Make
®