Troubleshooting - Schwinn AD2i Assembly Manual

Condition/Problem
Console will not power up/turn
on/start
Speed displayed is not
accurate
Speed displayed is always "0"/
stuck in Pause mode
No speed/RPM reading
Things to Check
Batteries
Check data cable integrity
Check data cable connections/
orientation
Check console display for
damage
Display set to wrong unit of
measure. (English/Metric)
Data cable
Check data cable integrity
Check data cable
connections/orientation
Check magnet position (re-
quires shroud removal)

TROUBLESHOOTINg

Solution
Make sure batteries are
installed correctly. If batteries
are correctly installed, replace
with a set of new batteries.
All wires in cable should be
intact. If any are visibly crimped
or cut, replace cable.
Make sure cable is connected
securely and oriented properly.
Small latch on connector
should line up and snap into
place.
Check for visual sign that
console display is cracked or
otherwise damaged. Replace
Console if damaged.
If the above steps do not
resolve the problem, contact
Customer Care for further
assistance.
Change display units.
Make sure the data cable is
connected to the back of the
Console and the main frame
assembly.
All wires in cable should be
intact. If any are cut or crimped,
replace cable.
Be sure cable is connected
securely and oriented prop-
erly. Small latch on connector
should line up and snap into
place.
Magnet should be in place on
pulley.
25