ProForm 130 Elliptical User Manual page 9

9. Identify the Left Handlebar (8) and the Left Upper Body
Arm (11), which are marked with stickers.
Orient the Left Handlebar (8) and the Left Upper Body
Arm (11) as shown, and insert the Left Handlebar into
the Left Upper Body Arm. Attach the Left Handlebar
with two M8 x 41mm Button Bolts (78) and two M8
Jamnuts (79). Make sure that the Jamnuts are in
the hexagonal holes in the Left Upper Body Arm.
Attach the Right Handlebar (9) to the Right Upper
Body Arm (12) in the same way.
10. Insert the Pivot Axle (74) into the Upright (3) and center
it. Apply a generous amount of the included grease to
the Pivot Axle.
Orient the Left Upper Body Arm (11) as shown, and
slide it onto the left end of the Pivot Axle (74). Slide
the Right Upper Body Arm (12) onto the right end of
the Pivot Axle.
Tighten an M8 x 23mm Button Screw (84) with an M8
Washer (88) and a Wave Washer (111) into each end
of the Pivot Axle (74). Make sure that the Wave
Washers are on the ends of the Pivot Axle.
9
79
Hexagonal
Holes
11
10
Grease
74
88
111
84
9
9
8
79
78
78
12
3
11
88
84
111
12