ProForm 130 Elliptical User Manual page 16

5. Measure your heart rate if desired.
If there are thin
sheets of plastic on
the metal contacts
on the handgrip
pulse sensor,
remove the plastic.
To measure your heart
rate, hold the handgrip
pulse sensor, with
your palms resting
against the metal contacts. Avoid moving your
hands or gripping the contacts tightly.
When your pulse is
detected, a heart-
shaped symbol will
flash in the left side of
the display each time
your heart beats, one
or two dashes will
appear, and then your heart rate will be shown.
For the most accurate heart rate reading, hold the
contacts for at least 15 seconds. Note: If you con-
tinue to hold the handgrip pulse sensor, the dis-
play will show your heart rate for up to 30 sec-
onds. The display will then show your heart rate
along with the other modes.
If your heart rate is not shown, make sure that
your hands are positioned as described. Be care-
ful not to move your hands excessively or to
Metal Contacts
6. Turn on the fan if desired.
7. When you are finished exercising, the console
16
squeeze the metal contacts tightly. For optimal
performance, clean the metal contacts using a soft
cloth; never use alcohol, abrasives, or chemi-
cals.
To turn on the fan at low speed, press the Fan but-
ton. To turn on the fan at high speed, press the
button a second time. To turn off the fan, press the
button a third time. Note: If the pedals are not
moved for a few minutes, the fan will automatically
turn off to conserve the batteries.
Pivot the thumb tab on
the right side of the fan
to adjust the angle of
the fan.
will turn off automatically.
If the pedals are not moved for several seconds, a
tone will sound and the console will pause.
If the pedals are not moved for about five minutes,
the console will turn off and the display will be
reset.
Thumb
Tab