ProForm 130 Elliptical User Manual page 7

4. Hold a Hub Cover (75) and a Crank Arm (36) against
the left Crank Hub (38). Align the holes in the Hub
Cover and the Crank Arm with the unused holes in
the left Crank Hub. Next, insert four Hub Screws (87)
into the Hub Cover and the Crank Arm, and finger
tighten the Hub Screws into the left Crank Hub.
Tighten one of the Hub Screws, and then tighten the
Hub Screw across from the first Hub Screw. Then,
tighten the remaining two Hub Screws.
Repeat this step on the right side of the elliptical exer-
ciser; make sure that the Crank Arms (36) are ori-
ented so that the Crank Bushing Sleeves (43) are
in the positions shown. Note: there are no Pulley
Screws (98) on the right side.
5. While another person holds the Upright (3), connect
the Upper Wire Harness (48) to the Lower Wire
Harness (49). Gently pull the upper end of the
Upper Wire Harness to remove any slack, and
insert the Upright into the Base (1). Attach the Upright
with an M8 x 69mm Button Bolt (80), an M8 Split
Washer (90), and an M8 Jamnut (79). Do not tighten
the Button Bolt yet; make sure that the Jamnut is
in the hexagonal hole in the Base.
Next, finger tighten two M8 x 23mm Button Screws
(84) with M8 Split Washers (90) into the Base (1). Do
not tighten the Button Screws yet.
Attach the Water Bottle Holder (22) to the Base (1)
with two M4 x 14mm Screws (104).
6. Orient one of the Upright Covers (17) as shown, and
hold it against the Upright (3). Attach the Upright Cover
with two M4 x 16mm Round Head Screws (101).
Attach the other Upright Cover in the same way.
4
38
36
75
87
87
43
5
80
90
90
84
6
17
101
7
43
98
36
3
48
49
79
90
84
104
22
1
3
101
17