Step9, Install Grillepanel - GE 36" Built-In Bottom-Freezer Installation Instructions Manual

Installation Instructions
[STEP 81 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130 °, you may change the door swing to a 90 °
opening. Skip this step if door opening is satisfactory
for your installation situation.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and lift off.
• Use pliers to unscrew door stop and reinstall into
the 90 ° position.
I I
PinLocation For
PinLocation
as Shipped
130° DoorSwing
• Reinstall the wire cover trim.
[STEP 9] INSTALL GRILLE PANEL
• Raise the grill panel to stop position.
Loosen I_
_ioe I
Trim
',
Screw
I
GrilleJ_
__ P_
AdjustNutBelow
Springto Accommodate
Panel W eight
Loosen
Side
Trim
Screw
• Loose screws on side trim behind frame. Remove
bottom trim.
• Slide panel over the metal baker panel and into the
trim.
• If necessary, tap with a wood block until panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
13