Authorisation

forgot your password?
Manuals → Brands → GE → Refrigerator → B480DR → Specification sheet

GE B480DR Specification Sheet

Ge monogram built-in side-by-side refrigerator specification sheet.

Download Manual (7 pages, 0.23 Mb) Add to your account Write a comment Upload Manual
1 2 3 4 5 6 7
 
ZISW/B480DR – GE Monogram 48" Built-In Side-by-Side Refrigerator
with Dispenser and Water Filter
Dimensions and Clearances (in inches)
The Installation Space
*Finished Width
6"
Electrical
84-1/2" max
Area
83-1/2" min
Finished
Opening
24"
5"
Water Supply
3-1/2"
Space is the first consideration when planning the installation.
The cutout depth must be 24"
The refrigerator will project forward, slightly beyond adjacent
696Dia15
cabinetry, depending on your installation.
The cutout depth beneath a soffit
When installed beneath a soffit, the soffit cannot exceed the
24" installation depth shown. The top case trim overlaps the
bottom of the soffit.
Electrical
A 115V, 60Hz., 15 or 20 amp power supply is required. An
individual properly grounded branch circuit or circuit breaker
is recommended. Install a properly grounded 3-prong electrical
receptacle recessed into the back wall. Electrical must be
located on rear wall as shown.
Note: GFI (ground fault interrupter) is not recommended.
Water Line
All models are equipped with an automatic icemaker. The
water line can enter the opening through the floor or back
wall. Route 1/4" O.D. copper tubing or GE QuickConnect
kit between the cold water line and the water connection
location. The copper tubing should be long enough to extend
to the front of the refrigerator. The installation of an easily
accessible shut-off valve in the water line is required.
Specification Revised 3/08
110179
36" Models 12"
42" Models 18"
48" Models 20"
5"
75" From Floor
to Bottom
of Electrical
Area
5"
3-1/2"
Listed by
Underwriters
Laboratories
47"
Case Width
25-3/8
*83-1/2"
at
Rear
48"
26-7/8"
Frame to Frame
including
handle
Door Swing Clearances
The installation must allow for clearances to adjacent walls or
cabinets. These refrigerators are equipped with a 2-position
door stop. The factory-set 130° door swing can be adjusted to
90° if clearance to adjacent cabinets or walls is restricted.
130° Door Swing
15"
20"
Allow minimum clearances for freezer door and fresh food
door for a full 130° door swing and to allow for pan removal.
• 4" minimum clearance is required when door swing is
adjusted to 90° . If the 90° door stop position is used, pan
access is maintained, but pan removal is restricted.
• See door swing illustrations to determine interaction with
adjacent cabinets or countertops.
Installation Information: Before installing, consult
installation instructions packed with product, or online at
Monogram.com, for current dimensional data.
For answers to your Monogram,
®
As an EnErgy StAr
gE
®
appliance questions, visit our website at
partner, gE has determined
that this product meets the
gEAppliances.com or call
EnErgy StAr guidelines
gE Answer Center
for energy efficiency.
* Shipping height.
The refrigerator
can be adjusted to
fit into a cutout that
is 83-1/2" min. to
84-1/2" max. height
*84" From
Note that the top
Floor to
case trim at the
Top Frame
front is 1/2" higher
and will overlap
upper cabinetry or
soffit. Use leveling
legs and wheels for
a maximum 1" height
adjustment.
90° Door Swing
23-7/8"
Behind
Frame
28-5/8"
4" Min.
to Wall
®
gE Profile
®
service, 800.626.2000.
™
or
Next page ->

Related Manuals for GE B480DR

Summary of Contents

  • Page 1

    ZISW/B480DR – GE Monogram 48" Built-In Side-by-Side Refrigerator with Dispenser and Water Filter Dimensions and Clearances (in inches) The Installation Space *Finished Width 6" Electrical 84-1/2" max Area 5" 83-1/2" min Finished Opening 24" 5" 5" Water Supply 3-1/2" Space is the first consideration when planning the installation.

  • Page 2

    ZISW/B480DR – GE Monogram 48" Built-In Side-by-Side Refrigerator with Dispenser and Water Filter Customization Basics: Framed or Overlay Panels, Custom Handles and Accessory Kits Trimmed Refrigerators ZIS480NRSS, ZISW480DRSS, ZISB480DRSS trimmed refrigerators are designed to be customized with decorative panels. Field-installed custom door and grille panels are required.

  • Page 3

    ZISW/B480DR – GE Monogram 48" Built-In Side-by-Side Refrigerator with Dispenser and Water Filter 3/4" Overlay Panel Dimensions For a more custom appearance, overlay panels may be installed on trimmed models. the overlay panel must be secured to a 1/4"-thick backer panel which slides into the trim.

  • Page 4

    ZISW/B480DR – GE Monogram 48" Built-In Side-by-Side Refrigerator with Dispenser and Water Filter 1/4" Framed Panel Dimensions If you choose to install framed panels, they must be cut to the dimensions shown. the panels will slide into the frame on the door and grille.

  • Page 5

    ZISW/B480DR – GE Monogram 48" Built-In Advance Planning for Built-In Custom Side-by-Side Refrigerators Use this page to determine door swing interaction with adjacent cabinets or countertops. Refrigerator Top View 130° Door Swing (Factory setting) Scale 1:1 IMPORTANT NOTE – FOR DISPENSER MODELS...

  • Page 6

    ZISW/B480DR – GE Monogram 48" Built-In Advance Planning for Built-In Custom Side-by-Side Refrigerators Use this page to determine door swing interaction with adjacent cabinets or countertops. Frameless Cabinets: the case trim overlaps cabinets at the top and sides. therefore, frameless cabinets may require filler strips to prevent interference with cabinet door swing.

  • Page 7

    ZISW/B480DR – GE Monogram 48" Built-In Side-by-Side Refrigerator with Dispenser and Water Filter ZISB480DR Specification Revised 3/08 110179 Features and Benefits • 30.7 cu. ft. total capacity • Overhead evaporator • Integrated Ice ™ System – the ice bucket is integrated...

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: