Sensor (Hcit Pass Through) With Cable Removal - Dell 5230dn Mono Laser Printer Service Manual

Sensor (HCIT pass through) with cable removal

Note: Carefully remove the base machine from the HCIT tray assembly before proceeding.
1. Remove the HCIT cover, left. Go to
2. Disconnect the sensor (HCIT pass through) cable connector from the HCIT controller card assembly.
Note: Remove the cable restraint, and observe the routing for reinstallation.
3. Release the hooks (A) securing the sensor (HCIT pass through) to the machine.
4. Remove the sensor (HCIT pass through) with cable from the top plate.
4-196
Service Manual
"High capacity input tray (HCIT) cover, left removal" on page
A
A
4-123.