Dell 5230dn Mono Laser Printer Service Manual page 65

Error
code or Error contents
message
203.08 Redrive motor load
error
203.10 Redrive motor control
failure.
Media tray 1
203.18 Redrive motor
assembly underspeed
error.
203.20 Redrive motor lost
encoder failure
Description/Action
The redrive motor assembly
has failed or caused high
mechanical load during the
warm up sequence.
The redrive motor does not
reach the proper operating
speed at the specified time.
The redrive motor assembly
does not rotate at the specified
speed.
The redrive motor is not
reporting pulses back to the
engine.
Possible repair actions
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to "Redrive
assembly removal" on
page 4-63.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
"Redrive
remains. Go to
assembly removal" on
page 4-63.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to "Redrive
assembly removal" on
page 4-63.
1. Check all connections on
the redrive motor assembly.
2. Check all connections on
the system card assembly.
3. Replace the redrive motor
assembly if problem
remains. Go to "Redrive
assembly removal" on
page 4-63.
Diagnostic information
2-31