Dell 5230dn Mono Laser Printer Service Manual page 67

Error
code or Error contents
message
230.08 Internal duplex drive
motor load error
Source = Internal
duplex
230.10 Internal duplex drive
motor control failure.
Source = Internal
duplex
230.13 sensor (duplex input)
static jam
Source = Internal
duplex
230.14 Paper jam around
internal duplex.
Source = Internal
duplex
Description/Action
The internal duplex drive motor
assembly has failed or caused
high mechanical load during
warm up sequence.
The internal duplex drive motor
motor does not reach the
proper operating speed at the
specified time.
Media remains on the sensor
(duplex input) during the warm
up sequence.
Page may be jammed in
internal duplex area.
Possible repair actions
1. Remove all media present
in media path.
2. Check all connections on
the duplex media entrance
drive motor assembly.
3. Check all connections on
the system card assembly.
4. Replace the duplex drive
motor assembly if problem
remains. Go to "Duplex
drive motor assembly
removal (5350dn, 5530dn,
and T656)" on page 4-18.
1. Remove all media present
in media path.
2. Check all connections on
the duplex media entrance
drive motor assembly.
3. Check all connections on
the system card assembly.
4. Replace the duplex media
entrance drive motor
assembly if problem
remains. Go to "Duplex
drive motor assembly
removal (5350dn, 5530dn,
and T656)" on page 4-18.
Go to sensor (duplex input)
static jam service check.
See "Sensor (duplex input)
lingering jam service check."
on page 2-136.
1. Remove all media present
in media path.
2. Check for obstructions in
media path.
3. Go to sensor (fuser output)
service check. See
"Sensor (fuser output)
service check" on
page 2-120.
4. Go to sensor (duplex input)
service check. See
"Sensor (duplex input)
service check" on
page 2-121.
Diagnostic information
2-33