Maintenance; Troubleshooting - Genie 4560 Operation & Maintenance Manual

A Monthly:
, Door springs and door hardware.:
- Oil door roller,bearings,and hingesusing silicone
lubricant or light oil.
DortotoperatedooraUtomatically or manually ifspringsI
are broken. Contacta GenieFactoryAuthorizedDealerfor
service or Call C ustomerServiceat IoBO0o35oGENJE. J
, BaBnceDoor.
- Closedoor.
- Release Magnetb CarriageAssemblyfrom RailAssembly
by pulling down on EmergencyRelease Knob.
- Raisedoor manually 3'- 4' and verify that door staysat
that position.SeeCheckStep2 on page 4.
When the door is 3'- 4' abovethe ground, the door
should stay open. Slight movement isacceptable, if
the door moves too much,contact a Genie Factory
Authorized Dealerfor service or call CustomerService
1-800-35-GENIE.
at
- ReattachMagneticCarriageAssembly t o RailAssemblyby
pulling the Emergency Release Knobtoward PowerHead.
- Closedoor.
Contact Reverse Test.
- Perform Adjustment 2 on page 8.
! WARNING
If the door fails to reverseon contact with the board
adjust the CloseForceControlasspecified in Set Jmit
Switchesand ForceControtson #age 7. If the Openerstill
fails,contact a GenieFactoryAuthorized Dealerfor service
or callCustomerServiceat loBO0.35.GENJE.
B Yearly:
Wipe off old excesslubricant from Drive Screw
Lubricate Drive Screwwith Genie Lubricant GLU-3t
UseONLYGenie Lubricant (GLU-3). Other lubricants
may damagethe Opener.
GLU-3
lubricant
FCC AND (C CERT(F(ED
ing interferencethat may causeundesired operation.
TROUBLESHOOTING GUIDE
Safe=T=Beam® System Self=Diagnostic Troubleshooting
Source (Red LED) Sensor (Green LED) Possible Problem Solution
ON ON Normal operation
o Power Head not powered • Check breakers, fuses, plugs
OFF OFF
o Wiring from Power Head bad o Check wiring for obvious shorts
OFF ON . Wiring to Source missing or bad . Check wiring
o Power has been interrupted o Remove power and reapply
2 BLINKS, Pause o Beam not aligned o Check Source, Sensor alignment
(Repeat) ON • Beam obstructed • Check for obstruction
• Sensor defective o Contact Customer Service
2 BLINKS, Pause • Wire to Sensor missing or bad • Check wiring
(Repeat) OFF • Sensor defective • Contact Customer Service
s BLINKS, Pause • Sensor receiving interference • Determine source of interference
(Repeat) ON • Contact Customer Service
4 BLINKS, Pause • Source not sending pubes • Contact Customer Service
(Repeat) ON o Source defective o Contact Customer Service
10
For Help, call 1-800-35-GENmE or visit www.geniecompany.com