Faxing Manually (G3 Fax) - Olivetti d-COLOR MF3000 Operation Manual

Faxing manually (G3 fax)

If a fax is sent manually, the status of the recipient can be confirmed before
the fax is sent.
In order to send a fax manually, the following requirements must be met.
The document cannot be divided and scanned separately. If the original
glass is being used, the document being sent can contain only one page.
F-code transmissions, timer transmissions, password transmissions and
polling reception are not being performed.
Automatic redialing cannot be used.
Multiple destinations cannot be specified.
The procedure for a manual transmission with [Off-Hook] pressed is
described below.
If [Admin Settings] - [Fax Settings] - [Fax Function Settings] - [Cofirm
Addr (TX)] is set to [ON], [Off-Hook] cannot be used.
1
Press [Fax] or press the [Fax] key to display the initial Fax screen.
–
For details on the initial Fax screen, refer to "Initial Fax screen" on
page 1-8.
2
Position the document to be faxed.
–
For details on loading the original document, refer to "Positioning the
original document" on page 3-4.
3
Press [Settings], and then select the appropriate settings on the [Scan
Settings], [Comm. Settings] and [Original Settings] screens.
–
For details on the [Scan Settings] screen, refer to "Specifying scan
settings" on page 3-11.
–
For details on the [Comm. Settings] screen, refer to "Specifying com-
munication settings (G3 fax)" on page 3-13 and "Useful transmission
functions (G3 fax)" on page 3-14.
–
For details on the [Original Settings] screen, refer to "Specifying docu-
ment settings" on page 3-18.
4
Press [Off-Hook].
5
Make sure that [Send] is selected.
6
Specify the destination.
–
Press
–
Press the [Mode Memory] key to select a program destination.
7
After the fax answer tone is heard, press [Start] or press the [Start] key.
The document is scanned and transmission begins.
3-22
to select a registered destination.
Faxing manually (G3 fax)