Using The Cash Register In A Password Protected Mode; Transaction Examples; Entering The Register Mode - Olivetti ECR 2400 Instructions Manual

Example: Define manager password 7654 for the X mode.
Type/Press:
[222222] + [Amt Tend/TOTAL] + [7654] + [Non Tax]
Using the Cash Register in a P Using the Cash Reg Using the Cash Reg Using the Cash Reg Using the Cash Reg ister in a Passw ister in a P ister in a P ister in a P
Mode Mode Mode
Mode Mode
If a manager password was defined to protect unauthorized access to
the PRG, Z and X machine modes, proceed as follows to enter the
specific passwords so that you can work normally in these modes:
1. Turn the PRG key to the PRG, X or Z position.
2. Type the specific 4-digit password that grants you access to the
required mode.
3. Press the [Check] key.
NOTE: If you attempt to use a protected machine mode without typing
the correct password, the cash register emits an error signal
and the message "SEC CODE" appears on the operator
display.
assw assw asswor or or or ord Pr assw d Protected d Pr d Pr d Pr otected otected otected otected
T T T T T ransaction Examples ransaction Examples ransaction Examples ransaction Examples ransaction Examples
This section provides examples on how to complete different types of
transactions. Sample receipts are included which reflect some of the
programming examples used in the chapter entitled Cash Register
Programming.
Enter Enter ing the Reg ing the Reg ister Mode ister Mode
Enter Enter Entering the Reg ing the Reg ing the Register Mode ister Mode ister Mode
The cash register has two register modes which can be used to record
ordinary sales transactions. These two modes are called REG 1 and
REG 2, where the only difference between the two is that in the REG 1
mode the cash register will automatically print the programmed header
on all customer receipts and journal records, while in the REG 2 mode
this header is not printed at all.
Proceed as follows to enter the register mode, assuming that you wish
to have the cash register print the programmed header:
1. Insert the control key into the Control Lock and turn it to the REG 1
position.
2. If the Clerk System option was set to active as explained in the
section entitled Clerk Numbers, Secret Codes and Names, enter the
related Clerk number assigned and its associated three-digit secret
code. If the Clerk System option was set to active and a secret code
was not programmed, type any Clerk number [1-15], the default
secret code [000] and then press the [Clerk] key.
31