Mmc: 200 Open Customer Programming - Samsung DCS Programming Manual

DCS
COMBINED PROGRAMMING MANUAL
MMC: 200
3 3
DCS
Used to open (enable) or close (disable) customer-level programming by the system administra-
tor. If programming is not opened and an attempt is made to access a customer-level MMC, the
error message [NOT PERMIT] will be displayed. A four-digit passcode is required to enable cus-
tomer programming (which can be changed in MMC 201, if required). Each digit can be 0 –9.
When opened, this MMC allows access to all MMCs specified by the system installer in MMC
802, Customer Access MMC Number.
PROGRAM KEYS
UP & DOWN
KEYPAD
SPEAKER
TRSF
ACTION
1. Press TRSF 200
Display shows
2. Enter passcode
Correct code shows
Incorrect code shows
3. Dial 1 for ENABLE or 0 for DISABLE
OR
Press UP or DOWN arrow key to select ENABLE or
DISABLE and press RIGHT soft key
4. Press SPEAKER to advance to MMC entry level and
press UP or DOWN key to select MMC (e.g. 212)
OR
Enter MMC number and press RIGHT soft
key to enter MMC
5. Press TRSF key to exit
Default Data:
Related Items:
OPEN CUSTOMER
PROGRAMMING
3 3
CI CII
Select open or closed
Used to enter passcode
Save data and advance to next MMC
Exit Programming
DISABLE (closed)
Passcode=1234
MMC 201 Change Customer Passcode
MMC 501 System-Wide Timers
MMC 802 Customer Access MMC Number
MMC 200 (Page 1 of 1)
3 3 3 3
816 408i
DISPLAY
ENABLE CUS.PROG.
PASSCODE:_
ENABLE CUS.PROG.
PASSCODE:
ENABLE CUS.PROG.
DISABLE
ENABLE CUS.PROG.
PASSWORD ERROR
ENABLE CUS.PROG.
ENABLE
212:ALARM RING
SELECT PROG. ID
MMC PROGRAMS
NOVEMBER 2001
3 3 3 3
408