Fan Removal Ci1250 Only - Regency Alterra CI1200 Owners & Installation Manual

MAINTENANCE
Prior to removing fan, disconnect / unplug power source to fan
1) Open door to a 45° angle
2) Holding door fi rmly from top and bottom - lift door up and off to remove.
Note: Door is heavy.
3) Remove two (2) screws (with 3/16" Allen Key) to remove lower cast sur-
round - set aside on a soft surface.
4) Lift fan housing up off pins on fl oor of unit.
Pins on unit fl oor
26
FAN REMOVAL
CI1250 ONLY
Fan Housing
5) Remove fan from unit.
6) Remove 3 screws to remove fan heat shield.
7) Slide back the protect sheath on the wiring - disconnect the black, red and
white wires.
Black
Red
White
8) Disconnect the ground wire located on the left side of the fan housing.
Ground
wire
9) To install fan - reverse Steps 8-1.
Regency CI1200 / CI1250 Wood Cast Insert