Cli: Viewing And Configuring Gvrp - HP PROCURVE 2610 Advanced Traffic Management Manual

3. Use the arrow keys to select the port you want, and the Space bar to select
Unknown VLAN option for any ports you want to change.
4. When you finish making configuration changes, press
Save) to save your changes to the Startup-Config file.

CLI: Viewing and Configuring GVRP

GVRP Commands Used in This Section
show gvrp below
gvrp page 3-14
unknown-vlans page 3-14
Displaying the Switch's Current GVRP Configuration. This command
shows whether GVRP is disabled, along with the current settings for the
maximum number of VLANs and the current Primary VLAN. (For more on the
last two parameters, see "Port-Based Virtual LANs (Static VLANs)" on page
2-4.)
Syntax: show gvrp
Shows the current settings.
Figure 3-6. Example of "Show GVRP" Listing with GVRP Disabled
GVRP
Introduction
, then (for
[Enter] [S]
3-13