Spanning-Tree Operation
Configuring Rapid Reconfiguration Spanning Tree (RSTP)
Menu: Configuring RSTP
1. From the console CLI prompt, enter the menu command.
2. From the switch console Main Menu, select
3. Press
4. Press the Space bar to select the version of spanning tree you wish to run:
5. Press the
6. Press the Space bar to select Yes to enable spanning tree.
5-20
ProCurve# menu
2. Switch Configuration ...
4. Spanning Tree Operation
(for Edit) to highlight the Protocol Version parameter field.
[E]
RSTP or STP.
Note: If you change the protocol version, you will have to reboot the switch
for the change to take effect. See step 9 and step 10.
or down arrow key to go to the STP Enabled field. Note that
[Tab]
when you do this, the remaining fields on the screen will then be appro
priate for the version of spanning tree that was selected in step 3. The
screen image below is for RSTP.