Installing The Router - Cisco 819 Installation Manual

Installing the Router

This chapter describes the equipment and the procedures for successfully installing the Cisco 819 ISR
and contains the following sections:
Equipment, Tools, and Connections, page 2-2
•
Installing the Router, page 2-4
•
Mounting the DC Power Supply, page 2-17
•
Note For compliance and safety information, see the Regulatory Compliance and Safety Information
Roadmap that ships with the router and the
Series and SOHO Series
Warning Read the installation instructions before connecting the system to the power source. Statement 1004
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Read the wall-mounting instructions carefully before beginning installation. Failure to use the
Warning
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system. Statement 378
OL-23125-02
Regulatory Compliance and Safety Information for Cisco 800
Routers.
Cisco 819 Integrated Services Router Hardware Installation Guide
2
C H A P T E R
2-1