Cisco 819 Installation Manual page 58

Installing the Router
Figure 2-10
1
O-ring
2 Power cord connector
Place the power cord lock onto the power cord behind the connector overmold as shown in
Step 2
Slide the power cord lock forward so that it captures the overmold and is fully seated.
Figure 2-11
1 O-ring
Step 3 Install the power cord with power cord lock and the pre-installed o-ring to mate with the power jack on
the router while making sure that the two arms of the power cord lock slide into the corresponding slots
on the router and are fully seated with both arms locking into the slots as shown in
Cisco 819 Integrated Services Router Hardware Installation Guide
2-14
Pre-assemble the O-Ring onto the Barrel
1
2
Place the Power Cord Lock onto the Power Cord
1
3
3
Power cord lock
2
2 Power cord lock
Chapter 2 Installing the Router
Figure 2-11.
Figure 2-12.
OL-23125-02