Ethernet Devices; Installing The Router; Warnings - Cisco 819 Installation Manual

Installing the Router

Ethernet Devices

Identify the Ethernet devices that you will connect to the router: hub, servers, and workstations or PCs.
Ensure that each device has a network interface card (NIC) for connecting to Ethernet ports.
If you plan to configure the software using Cisco IOS commands through the console port, provide an
ASCII terminal or a PC that is running terminal emulation software to connect to the console port.
If you plan to connect a modem, provide the modem and modem cable.
Installing the Router
This section describes how to install the Cisco 819 ISR. These routers can be installed on a table top or
other flat horizontal surface mounted on a wall or DIN rail.
The recommended clearance when horizontally mounted is 1.5 inches on both sides for floor mount
bracket clearance and 2 inches on top. Top clearance is not required but stacking heat-dissipating objects
on top of the router is not allowed. I/O side clearance is needed as it is required to access the cable
connections. Clearance is not required on the backside (opposite side from I/O face) unless DIN rail
mounting is required. Clearance is required to attach and mount the DIN rail bracket. The same
clearances apply when mounted vertically.
This section also describes how to attach external antennas to the routers and contains the following
topics:
•
•
•
•
•
•
•
•
•
•

Warnings

Warning This equipment needs to be grounded. Use a green and yellow 12 to 14 AWG ground wire to connect
the host to earth ground during normal use. Statement 242
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Cisco 819 Integrated Services Router Hardware Installation Guide
2-4
Warnings, page 2-4
Accessing the SIM Card, page 2-5
Installing Antennas, page 2-6
Installing a WiFi External Antenna, page 2-7
Installing on a Table, page 2-8
Mounting on a Wall, page 2-8
Installing a DIN Rail, page 2-10
Installing the Router Ground Connection, page 2-12
Installing the Power Cord Retention Lock, page 2-13
Installing the Power Switch Lock, page 2-15
Chapter 2 Installing the Router
OL-23125-02