Installing The Power Switch Lock - Cisco 819 Installation Manual

Chapter 2 Installing the Router
Figure 2-12
Step 4 To remove the power cord lock, use your thumb and index fingers to squeeze ends of tabs while pulling
away from the router. (See
Figure 2-13

Installing the Power Switch Lock

The Cisco 819 ISRs have a power switch lock as an accessory. The power switch lock prevents
unauthorized access to a tampered proof router (for example, router in a bus). For the complete list of
Cisco 819 ISRs that support power switch lock, see
This section describes how to install the power switch lock.
Install the power switch lock by following the parts listed in
Step 1
accessory kit in their own bag. The ring terminal does not have to be installed.
power switch lock installed.
OL-23125-02
Installing Power Cord Lock onto the Router
Figure 2-13.)
End of Tabs
1
End of tabs
Cisco 819 Integrated Services Router Hardware Installation Guide
1
Table 1-4.
Figure 2-14. All these parts are in the
Installing the Router
Figure 2-15 shows the
2-15