Canon JX510P User Manual page 89

CHK PRINTER B200 / REQUIRE SERVICE
Cause
An error requiring servicing might have
occurred.
CHK PRINTER nnnn / SEE MANUAL
Cause
An error requiring servicing might have
occurred.
CLEAR PAPER JAM
Cause
There is a paper jam.
DOC. TOO LONG
Cause
The document is longer than 400 mm.
ECM RX
Cause
The fax is receiving a document using
Error Correction Mode (ECM).
ECM TX
Cause
The fax is sending a document using
Error Correction Mode (ECM).
INK ABS NEAR FUL
Cause
The ink absorber is almost full.
INK VOL UNKNOWN
Cause
The remaining level of the ink cannot
be correctly detected.
If using the machine as phone, contact the service center, then turn off the
machine immediately.
If not using as phone, turn off the machine immediately, then contact the service
center using your phone.
Turn off the machine, and unplug the power cord of the machine from the power
supply. After a while, plug the power cord of the machine back in and turn on the
machine. If the same error occurs, contact the service center.
Clear the paper jam (see page 72) and reload paper in the Rear Tray. Press
[Stop/Reset].
Use a copier to make a reduced copy of the document and then send the copy.
ECM receptions may take longer than normal receptions. Turn off ECM if you
need to receive quickly, or if you know your local lines are in good condition (see
<ECM RX> on page 57).
ECM transmissions may take longer than normal transmissions. Turn off ECM if
you need to transmit quickly, or if you know your local lines are in good condition
(see <ECM TX> on page 57).
Printing will no longer be possible once the ink absorber is full. Contact the
service center immediately. Press [Stop/Reset] to continue printing.
A FINE Cartridge that was once empty is installed. Replace the FINE Cartridge
(see page 62).
Action
Action
Action
Action
Action
Action
Action
Action
Troubleshooting 87