Canon JX510P User Manual page 91

Hide thumbs Also See for JX510P:
Table of Contents

Advertisement

SET DOCUMENT IN CORRECT POSITION
Cause
The document cannot be correctly
detected or the document is too small.
TAM MEMORY FULL*
Cause
Either 55 messages, including an
outgoing message, alternative
message, voice memos, Fax/Tel
message and forwarding message,
have been recorded or the total
maximum recording time of 30 minutes
has been reached.
* JX510P only.
TX/RX CANCELLED
Cause
You pressed [Stop/Reset] to cancel the
transmission.
TX/RX NO. nnnn
Cause
When the fax sends or receives a
document, it assigns it a unique
identification number (nnnn).
Status Monitor Messages
The following messages are displayed on the status monitor when the machine is performing a
function or encounters an error.
Service Error 5100 Is Displayed
Cause
Movement of the Holder is blocked.
There may be an obstruction that is not
allowing the Holder mechanism to
move.
The FINE Cartridge may be defective.
An error requiring servicing might have
occurred.
Make sure the document meets the requirements and is correctly loaded. If
necessary, reload the document and press [Start/Copy]. See "Document
Requirements" on page 19 and "Loading Documents and Paper" on page 21.
Listen to your telephone messages and delete any unnecessary messages.
Alternatively, erase all telephone messages stored in the fax memory (see
page 46).
If required, try sending again.
Write the number down if you will need it later.
Clear the paper jam or foreign object that is preventing the Holder from moving,
then turn off the machine and turn it back on again.
Check for any obstruction (paper clip, small object, etc.) and also that the
protective tape are removed from the FINE Cartridge. Check also for a paper
jam and clear the jam if necessary (see page 72). Then press [Stop/Reset] and
start again.
Press [Stop/Reset]. Reinstall the FINE Cartridge (see your setup sheet or
page 62) and start again.
In either case, if the error does not clear, try unplugging the printer. Wait several
minutes, then plug it back in. Also, try replacing the FINE Cartridge with a new
one (see page 62).
Turn off the machine, and unplug the power cord of the machine from the power
supply. After a while, plug the power cord of the machine back in and turn on the
machine. If the same error occurs, contact the service center.
Action
Action
Action
Action
Action
Troubleshooting
89

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fax-jx210Qt5-2227-v02Jx210p

Table of Contents