Fisher & Paykel OR90SDBSI Installation Instructions And User Manual page 11

Fitting the anti-tilt bracket
Important!
To restrain the appliance and prevent it tipping
accidentally, fit a bracket to its rear to fix it
securely to the wall.
For New Zealand and Australia only: make
sure you also fit the supplied lock pin to the
anti-tilt bracket.
If installing the cooker above a plinth (without
fitting the adjustable feet), revise the
installation dimensions accordingly
considering that the feet have the following
measures: min 155 mm - max 180 mm.
To fit the anti-tilt bracket:
After you have located where the cooker
1
is to be positioned, mark on the wall the
place where the two screws of the anti-tilt
bracket have to be fitted. Please follow the
indications given in Fig10a.
Drill two 8 mm diameter holes in the wall
2
and insert the plastic plugs supplied.
Important!
Before drilling the holes, check that you will not
damage any pipes or electrical wires.
Loosely attach the anti-tilt bracket with the
3
two screws supplied.
Move the cooker to the wall and adjust the
4
height of the anti-tilt bracket so that it can
engage in the slot on the cooker's back, as
shown in Fig.10a.
Tighten the screws attaching the anti-tilt
5
bracket.
Push the cooker against the wall so that the
6
anti-tilt bracket is fully inserted in the slot
on the cooker's back.
New Zealand and Australia only: access the
7
bracket and fit the lock pin;
Open the pivoting panel (Fig. 10b).
Fit the lock pin through the bracket,
as shown (Fig.10c).
Close the pivoting panel.
Installation instructions
0
+ 25
Fig. 10a Fitting the anti-tilt bracket
Fig. 10b Opening the pivoting panel
1
Lock pin
Slot on the
cooker's back
2
Lock pin
correctly
fi tted
Fig. 10c New Zealand and Australia only: fitting the
min 210 mm
max 235 mm
(depending on feet adjustment)
Pivoting
panel
Anti-tilt bracket
attached on the
rear wall
Cooker's
back
lock pin through the bracket
9