Fisher & Paykel OB90 User Manual page 37

Problem
Self Clean function
During a Self Clean
cycle, the oven is louder
than usual.
The display shows
door
.
The display shows
0:00 but the oven door
will not open.
At a point during a Self
Clean cycle, the function
dial halo goes out
and the temperature
indicator starts
displaying cascading
bars
.
I have cancelled a Self
Clean cycle but cannot
use the oven:
the oven door will not
open
the display is still
counting down
minutes or showing
0:00
the Self Clean
function indicator is
still lit
the temperature
indicator shows
cascading bars
the dials and buttons
are unresponsive.
The oven is beeping and
the display shows
A3.
Possible causes
This is normal: the oven's cooling fans operate at their highest speed.
The door has not been properly
closed.
The oven door is locked because
the oven is still too hot to be used
for cooking.
This is normal: the oven is
in the last phase of the Self
Clean cycle, cooling down.
This is normal: if the function dial
halo is unlit, you have
successfully cancelled the
Self Clean cycle. However, the
oven is still too hot to be
used for cooking and
needs to cool down.
See section 'Alert codes' for instructions.
or
Troubleshooting
What to do
Make sure you close the door
properly.
Wait until the Self Clean cycle
has finished. If you cancelled a
Self Clean cycle which was
already underway, the oven
still needs to cool down before
it can be used. The oven door
will automatically unlock.
Wait until the Self Clean cycle
has finished. A long tone will
sound and the oven door will
automatically unlock when the
oven is ready to use.
Wait until the cool-down phase
has finished. A long tone will
sound and the oven door will
automatically unlock when the
oven is ready to use.
Note: depending on when the
Self Clean cycle was cancelled,
the cool-down phase may take
up to 45 minutes.
35