SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTIONS WARNING ! Electrical shock hazard To avoid hazard, follow these instructions carefully Always disconnect the appliance from the before installing or using this appliance. mains power supply before Make this information available to the person carrying out any maintenance or repairs.
PRIOR TO INSTALLATION IMPORTANT! Some environmental factors and cooking habits can cause condensation in and around the oven during use. To protect surrounding cabinetry from possible damage caused by frequent or excessive condensation, we recommend moisture-proofing the oven cavity. Before you install the oven, make sure: it will be lifted by two people.
PRODUCT DIMENSIONS FRONT SIDE OB90 MODELS PRODUCT DIMENSIONS (MM) Overall height of product (including upper and lower vents) Overall width of product Depth of oven front and control panel (distance between front of chassis and front of oven door, excluding knobs)
Electrical supply 16-20 mm min. 2.5 mm Ensure the cavity is completely sealed with no gaps SIDE OB90 MODELS CABINETRY DIMENSIONS (MM) Minimum height of inside cavity Minimum inside width of cavity Overall width of cabinetry Minimum inside depth of cavity...
DISCARD PACKAGING RESPONSIBLY IMPORTANT! WARNING! When you remove the oven from the carton be careful not to damage the lower trim. The trim is important for both ventilation Very Heavy and to ensure the door opens fully without obstruction Do not attempt to lift this product unassisted.
Page 7
This oven must be earthed. MODEL MAX POWER (W) VOLTAGE (V) AMPS (A) OB90 4730 220 – 240 V~ 20.56 Before connecting the oven to the mains power supply, check: the domestic wiring system is suitable for the power drawn by the oven (as specified on the rating plate)
Page 8
SECURE THE OVEN TO THE CABINETRY IMPORTANT! Take care not to damage the upper trim of the oven or the door sensor lever. Do not over-tighten the screws. Do not seal the oven into the cabinetry with silicone or glue. This makes future servicing difficult.
TROUBLESHOOTING IF THE APPLIANCE IS NOT FUNCTIONING CORRECTLY AFTER INSTALLATION CHECK THE FOLLOWING: That the circuit breaker has not tripped or the fuse blown. Make sure that the electrical connections have been correctly made. Make sure that power is being supplied to the oven. Make sure the voltage is correct across all phases.
FINAL CHECKLIST TO BE COMPLETED BY THE INSTALLER: Make sure the oven is level and securely fitted to the cabinetry and the oven door opens and closes freely. Make sure all the internal packaging has been removed from the oven cavity. Make sure all oven vents and openings are clear and are free of any obstruction/damage.