How To Assign Security Codes And Attributes - Honeywell ADEMCO VISTA-10P User Manual

Security Codes & Authority Levels Security Codes & Authority Levels
Security Codes & Authority Levels Security Codes & Authority Levels
How to Assign Security How to Assign How to Assign How to Assign Security Security Codes and Attributes Security
The following lists the command strings for adding user codes and attributes.
Refer to the User Setup chart at the back of this manual for factory
assignments of user attributes and to keep a record of user programming.
Change System
Master Code
Add a User:
Delete a User:
Authority Level:
Factory Assignments:
users 03-16 = 0
Access Group:
Factory Assignments: none
RF Zone Number:
(adding a Key Fob)
Factory Assignments: none
Pager On/Off:
Factory Assignments:
users 01-16 = 1 (on)
Codes and Attributes Codes and Attributes Codes and Attributes
System Master code + [8] + 02 + new Master code + new code again
The System Master code can be changed only by using the current
System Master code or by the Installer using the Installer code.
System Master code + [8] + user no. + new user's security code
User 01 = installer
User 02 = master
The Keypad beeps once to confirm that new user was added.
System Master code + [8] + [user no.] + [#] [0]
The security code and all attributes set for this user number,
including any associated RF keys, are erased from the system.
System Master code + [8] + [user no.] + [#] [1]+ auth. level
Authority Levels (see definitions on previous page):
0 = standard user
1 = arm only
System Master Code + [8] + [user no.] + [#] [2]+ group (1-8)
You can assign users to a group, then set an access schedule that
defines the times this group of users can operate the system. The
system ignores these users outside the scheduled times.
System Master Code + [8] + [user no.] + [#] [4]+ zone no.
Use this command to assign a wireless button device (key fob) to a
user for arming/disarming functions (key fob must be enrolled in
system first; see your installer).
Zone number: enter the zone number assigned to a button on the
key fob that will be used for arming/disarming by this user.
Deactivating a key fob: You can deactivate the arming/
disarming functions for a key fob (ex. if lost or stolen) by deleting
the associated key fob user. See "Delete a User" above. Other key
fob functions such as panic or device activation (if programmed)
remain active. To fully remove the programming for a key fob, see
your installer.
System Master Code + [8] + [user no.] + [#] [5] + 0 or 1
ou can program a user so that a message is sent to a pager
Y
whenever this code is used to arm or disarm the system.
Paging On/Off: 1 = allow paging; 0 = no paging for this user
User 03-17 = standard users
(factory set master code is 1234)
2 = guest
3 = duress
(Cont.) (Cont.)
(Cont.) (Cont.)
– 31 –