Bypassing Protection Zones; Using The Bypass Key - Honeywell ADEMCO VISTA-10P User Manual

Bypassing Protection Zones

Bypassing Protection Zones
Bypassing Protection Zones Bypassing Protection Zones

Using the BYPASS Key

Using the BYPASS Key
Using the BYPASS Key Using the BYPASS Key
Use t
his key when you want to arm your system with one or more zones intentionally
unprotected.
Vent Zones: Your system may have certain windows set as "vent" zones, which are
automatically bypassed if left open when arming the system (you do not need to
manually bypass them). However, if a vent zone window is closed after arming, it
becomes protected and will cause an alarm if opened again while the system is armed.
When bypassing zones:
• The system must be disarmed before you can bypass zones.
• Bypassed zones are unprotected and will not cause an alarm if violated.
• The system will not allow fire zones to be bypassed.
• Zones are automatically unbypassed when the system is disarmed.
1.
(Security Code)
Enter the 2-digit zone number for the zone to be
bypassed. Single digit zone numbers must be
preceded by a zero (e.g. 05, 06).
Repeat the command string for each zone to be
bypassed.
2. After each command string, the keypad
momentarily displays a "Bypass" message for the
bypassed zone number.
Arm the system as usual. When armed, the arming
message is displayed with "ZONE BYPASSED."
To display bypassed zones prior to arming, enter
your security code and press the [6] BYPASS key.
– 20 –
+ 6 + zone number (see below)
BYPASS
Alpha Display:
DISARMED
HIT * FOR FAULTS
Fixed-Word Display: NOT READY
Alpha Display:
DISARMED BYPASS
READY TO ARM
Fixed-Word Display: BYPASS
ARMED: STAY
ZONE BYPASSED
Typical armed alpha display after
bypassing zones.