To Assign Security Codes And Attributes - Honeywell First Alert FA168CPS User Manual

Security Codes & Authority Levels Security Codes & A
Security Codes & A Security Codes & A
How to Assign How to Assign Security How to Assign How to Assign Security Codes and Attributes Security Security
The following lists the various command strings for adding security codes and attributes
Refer to the User Setup chart at the back of this manual for factory
assignments of user attributes and to keep a record of user programming.
NOTE: Partition Master codes (FA168CPS only) apply only to those user numbers
previously assigned (by the system master/installer) to the partition master's partition.
Add Security Code:
( Users 03/33 are preset
to partition programmers,
but can be changed.)
Delete Security Code:
Authority Level:
Factory Assignments:
users 04-32/34-49 = 0
users 03/33 = 4
Access Group:
Factory Assignments: none
User's Partition:
(FA168CPS only)
Factory Assignments:
Part. 1 = users 03-32
Part. 2 = users 33-49
RF User Number:
Factory Assignments: none
Pager On/Off:
Factory Assignments:
users 01-49 = 1 (on)
uthority Levels
uthority Levels uthority Levels
Codes and Attributes Codes and Attributes Codes and Attributes
System/Partition Master code + [8] + user no. + new user's security code
User 01 = installer
User 02 = master
The Keypad beeps once to confirm that new user was added.
System/Partition Master code + [8] + [user no.] + [#] [0]
The user code and all attributes* programmed for this user number,
including any associated RF keys, are erased from the system.
(*except assigned partition)
System/Partition Master code + [8] + [user no.] + [#] [1]+ auth. level
Authority Levels (see definitions on previous page):
0 = standard user
1 = arm only
2 = guest
System/Partition Master Code + [8] + [user no.] + [#] [2]+ group (1-8)
You can assign users to a group, then set an access schedule that
defines the times this group of users can operate the system. The
system ignores these users outside the scheduled times.
System Master Code + [8] + [user no.] + [#] [3] + [0] + partition(s) + [#]
This command assigns the partitions the user can access. If more
than one, enter partition numbers sequentially, then press [#] to end.
E.g., master code + [8] + [user no.] + [#] [3] + [0] + [1] [2] + [#] gives
the user access to partitions 1 and 2 and the common partition.
Partition Entries: 1 = partition 1 and common
2 = partition 2 and common
3 = common partition only
Master/Part. Prog. Code + [8] + [user no.] + [#] [4]+ zone no.
Use this command to assign a wireless button device (keyfob) to this
user (keyfob must be enrolled in system first; see installer).
Zone number: enter the zone number assigned to a button on the
keyfob that will be used for arming/disarming by this user.
Master/Part. Prog. Code + [8] + [user no.] + [#] [5] + 0 or 1
ou can program a user so that a message is sent to a pager
Y
whenever this code is used to arm or disarm the system.
Paging On/Off: 1 = allow paging; 0 = no paging for this user
User 03 = partition 1 master
User 33 = partition 2 master
3 = duress
4 = partition master (FA168CPS only)
(Cont.) (Cont.)
(Cont.) (Cont.)
– 31 –