Mount The Oven - GE SCB1000 Installation Instructions Manual

Installation Instructions
_] Secure blower unit to oxen with the screw remoxed
in Step 2.
F7] Replace blower plate with the screws remoxed
in Step 1.
Retaining
Flange _'
_,_---Blower PlateScrews
_ Blower Plate
_ •
_._ Back of Oven
"_-_-- Blower Motor
Screw
I-C- MOUNT THE OVEN
FOR EASIER INS%MLA, TION AND PERSONAL SMCETY,
X4'E RECOMMEND THAT TWO PEOPLE INSTALL
THIS OVEN.
IMPORTANT: Do not grip or use hm_dle during
h_staJlation.
NOTE: If w)m" cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting oI the cord.
NOTE: _e recommend using filler blocks if the cabinet
fl'ont hangs below the cabinet bottom shel£
IMPORTANT: If f'filer blocks axe not used, case dmnage
may occur from over tightenh_g screws.
NOTE: X,_q_enmotmting the oven,
thread power cord through hole
in bottom of top cabinet. Kee I) it
tight throughout Steps 1-3.
Do not pinch cord or lift oven
by pulling
[_I,ifl flit it
oven,
torward, and
hook slots at back
bott()n} edge onto
2 lower tabs ot
inounfing plato.
[]
[]
Rotate fl'ont _ff oven up
against cabinet bottom.
Insert a self aligning screw through top center cabinet
hole. Temporarily secme the oven by tm'ning the
screw at least two full tur_s alter the threads have
engaged. (It will be completely tightened late_:)
Be sure to keep power cord tight. Be careful not to
pinch the cord, espedaJly when momathag flush to
bottom of cabinet.
If your cabinet fl'ont hangs more than 2:"A"below the
cabinet bottom, you may need to use longer screws than
the ones provided with this product. The screws provided
with this product (hardware item 3) are self:aligning,
lmge-head machine screws 1/4" diameter; 3¼" long,
with SAE 28 threads per inch. It is impommt that you
use replacement screws just long enough m attach the
product to the cabinet. The length can be detemfined
by measuring the height ot the overhang fl'om the top
of the cabinet floor to the bottom of the overhang and
adding l" to that length. This will be the length ot the
1/4" SAE 98 threads per inch screws w)u need.
You will also need to use washers 3/4" diameter to fit the
scre_:s wm l)m'chase. This will prevent the screw heads
fl'om pulling through the bottom ot the cabinet when
tightening dm-ing installation.
21