Mount The Oven - GE MONOGRAM ZTSX1FPSNSS Installation Instructions Manual

9
SLIDE OVEN INTO OPENING
• Lift oven into cabinet cutout using
the oven opening as a grip. Carefully
push against oven front frame. Do
not push against outside edges.
10

MOUNT THE OVEN

WARNING
Mounting screws must be used. Failure to do so could result in the oven
falling out of the cabinet, causing serious injury.
NOTE: During oven mounting step, ensure that no damage is done to oven gasket which lines
the edge of oven cavity.
NOTE: Before drilling the pilot holes, make sure the oven is pushed as far back into the opening
as it will go and is centered.
NOTE: If the cabinet is particle board, you must use #8 x ¾" particle board screws. These may
be purchased at any hardware store.
A. Drill through the mounting holes (top and bottom) of the side trim for the #8 mounting screws
provided.
B. Secure the oven cabinet with the screws provided.
The Screws Must
Be a Minimum of
1/4" (6 mm) From the
Front of the Cutout.
Mounting
Hole
Locations
(hole locations
may vary)
Mounting
Hole
Locations
(hole locations
may vary)