Outside Top Exhaust; Attach Mounting Plate To Wall - GE SCB1000 Installation Instructions Manual

Installation Instructions
_ OUTSIDE TOP EXHAUST
(Vertical Duct)
INSTALLATION OVERVIEW
A1. Mmch Morn]ring Plate to Will
A2. Prepare Top Cabinet
A3. Install Adaptor
A4. M(mnt the (-)yen
AS, A(!iust Exhaust Adaptor
A6, Connect Ductwork
|
VA-_ ATTACH THE MOUNTING
PLATE TO THE WALL
, , i
Attach the plate to the wall using toggle bolts, At least one
wood screw m ust be used to attach the plate to a wall stud.
_ Remoxe the toggle wings fl'om the bolts.
_] Insert the bolts into the mortaring plate through the
holes designated to go into drywall, and reattach the
toggle wings to 3/4" onto each bolt,
To use toggle bolts:
Spacingfor TogglesMore
+]*,-,..j*,_Than
W all Thickness
i Toggle . i, i
7Jags
II I;:k
Mounting--->- ..
'll
Toggle !
End
Bolt o
Wall
_] Place the
IllOtlnting plate against
the wall and insert
the toggle wings into the holes in the wall to motmt
the plate.
NOTE: Befin'e tightening toggle bolts and wood scre_;
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the wall
and that the plate is properly centered under the cabinet.
CAUTION:
Be carefl,1 to avoid )iilchiilg
I
finge_s between the back of the motmting plate and
the wall.
[_] Tighten all bolts. Pull the plate awa) fl'om the wall
to help tighten the bolts.
12