GE SCB1000 Installation Instructions Manual
Speedcook oven
Hide thumbs
Also See for SCB1000:
- Owner's manual (72 pages) ,
- Installation instructions manual (24 pages) ,
- Owner's manual (36 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Owner's Manual
Installation
Instructions
Speedcook
Oven
Questions?Call 800.GE.CARES(800.432.2737)or Visit,,,H-x_ e bsite_,t:www.GEAppliances.com
I
BEFORE YOU BEGIN
Read these hlstructions
completely
mid ca_refully.
• IMPORTANT
- S_,,e these i nstructions
lot local inspector's
use.
• IMPORTANT
- Obse,,e _,ll _o, eH,in_
codes and ordinances.
•
Note
to Installer
- Be sure to leaxe these instructions
with the Consume_:
• Note to Consumer
- Kee I) these instructions
fi_r
fllttu'e reterence.
• Sldll level - Installation of this appliance requires basic
mechanical and electrical skills.
• Proper
installation
is the
responsibilit}
of the
installe_:
• Product
thiltu'e
due
to
improper
installation
is not
coxered
trader
the _n'rant_.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
Advertisement
Table of Contents
Related Manuals for GE SCB1000
Summary of Contents for GE SCB1000
- Page 1 Installation Speedcook Oven Instructions Questions?Call 800.GE.CARES(800.432.2737)or Visit,,,H-x_ e bsite_,t:www.GEAppliances.com BEFORE YOU BEGIN • Note to Consumer - Kee I) these instructions fi_r Read these hlstructions completely mid ca_refully. fllttu'e reterence. • IMPORTANT - S_,,e these i nstructions • Sldll level - Installation of this appliance requires basic lot local inspector's use.
-
Page 2: Table Of Contents
Installation Instructions CONTENTS Recirculafing ..........19-22 Attach Mounting Plate to Wall ....19 General information Preparation of Top Cabinet ....lmporta_t Safety h_structions ........Adapting Blower fl)r Electrical Requirements ..........Recirculation ........20, 21 Hood Exhattst ............4, 5 Mount the Oven ...... -
Page 3: Lmporta_T Safety H_Structions
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS This product requires a 4-i)ron_*_grounded outlet. You should have the wall receptacle mad circuit checked installer must perlimn a ground continui_, check on the by a qualified electricim_ to make sure the receptacle power outlet box before beginning the installation properly grounded. -
Page 4: Hood Exhattst
Installation Instructions HOOD EXHAUST NOTE: Read these next two pages only if you plml to vent your exhaust to the outside. If you plma to recirculate the air back into the room, proceed to page OUTSIDE TOP EXHAUST (EXAMPLE ONLY) fi>llowing chart describes... - Page 5 Installation Instructions NOTE: If wm need to install ducts, note that total duct Maximum duct length: length of 3¼" x ] 0" rectangular or 6" dianmter round duct For satisfi_ctory air movement, total duct length should not exceed 140 equivalent feet.
-
Page 6: Dmnage_Hipment/H_Stajlation
Installation Instructions PARTS INCLUDED DAMAGE--SHIPMENT/ INSTALLATION ADDITIONAL PARTS * If the unit is dmnaged in shipment, return unit QUANTITY PART to the store in which it was bought fin" repair TopCabinet replacement. Template TOP CABINETTEMPLATE • If the refit is dmnaged by the customer, repair... -
Page 7: Tools You Will Need
Installation Instructions TOOLS YOU WILL NEED Ruler ortape measure Pencil Carpentersquare # 1 and#2 Phillipsscrewdriver aight edge (optional) LEd.,E&,_&,_d,J._.,I.,_d.,b,h,,h,l,,,h._,,h,,l,,h,,h,h,,I,,d,,,I,,,l,,I,,,iJ Tinsnips(for cutting damper,if required) Scissors Electric drill with 3/167 7/16," (to cut template, if necessary) 1/2" and 5/8" drill bits Filler blocks or scrap wood pieces, if needed for top cabinet spacing (used on recessed bottom... -
Page 8: Placement Of Momlthag Plate
Installation Instructions PLACEMENT OF THE MOUNTING PLATE I-A--1 REMOVING THE OVEN FROM FINDING THE WALL STUDS THE CARTON/REMOVING MOUNTING PLATE Remoxe containing instnllation instructions, filte_, exhaust adaptor small hardware bag. Stnnd oxen on its control panel side. Use a portion ot the carton or some... -
Page 9: Detemfining Wall Plate I,Ocation
Installation Instructions _--] DETERIVIINING WALL PLATE LOCATION UNDER YOUR CABINET Plate positionmbeneath flat bottom Plate positionmbeneath framed recessed cabinet cabinet bottom PlateTabs Mounting Plate Tabs i the Cabinet the Back Bottom Frame 30" to Cooktop At least 30", up to 36" Plate position_beneath recessed bottom... -
Page 10: Migning The Wall Plate
Installation Instructions i--_ ALIGNING THE WALL PLATE HoleA-[ Hole C/ NOTE: Holes C and D are inside area E. If neither CAUTION: C nor D is ill a stud, find a stud SOlnewhere ill area E on shaq) edges. and draw a fifth drcle to line up with tile stud. -
Page 11: Installation Types
Installation Instructions INSTALLATION TYPES (Choose A, B or C) This oven is designed fi)r adaptation to the fi)llowing NOTE: This ()veil is shipped assembled Outside 3 types of ventilation: Exhaust. Select type of ventilation required vour installation proceed to that section. -
Page 12: Outside Top Exhaust
Installation Instructions OUTSIDE TOP EXHAUST (Vertical Duct) INSTALLATION OVERVIEW A1. Mmch Morn]ring Plate to Will A2. Prepare Top Cabinet A3. Install Adaptor A4. M(mnt the (-)yen AS, A(!iust Exhaust Adaptor A6, Connect Ductwork To use toggle bolts: VA-_ ATTACH THE MOUNTING PLATE TO THE WALL Spacingfor TogglesMore +]*,-,..j*,_Than... -
Page 13: Preparation Of Top Cabinet
Installation Instructions VK_ USE TOP CABINET TEMPLATE MOUNT THE OVEN FOR PREPARATION OF TOP CABINET Ybu need to drill holes for the top support screws, a hole lmge enough fin" tile power cord to fit through, and a ctltotlt lmge enough fin"... -
Page 14: At!Just The Exhaust Adaptor
Installation Instructions Install grease filte_5. IA4-1 MOUNT THE OVEN (cont.) See tile Owner's Manual packed with the oven. If your cabinet fl'ont hangs more than 2'_A " below tile Remove tile tape fl'om tile cabinet bottom, you may need to use longer screws than cooktop lan/p covei3 on... -
Page 15: Outside Back Exhaust
Installation Instructions OUTSIDE BACK EXHAUST (Horizontal Duct) INSTALLATION OVERVIEW Rear Wall B1. Prepare B2. Attach Mounting Plate to XMfll B3. Prepare Top Cabinet B4. A(!iust Blower B5. Mount tile Oven Attach tile exhaust adaptor to tile rear mortaring plate [-B-_ PREPARING THE REAR WALL b) sliding it into gukles... -
Page 16: Attach Mounting Plate To X_Hll
Installation Instructions FB--_ATTACH THE MOUNTING VB-3-] U SE TOP CABINET TEMPLATE PLATE TO THE WALL FOR PREPARATION OF TOP CABINET need to drill holes for the top support screws and a hole large enough t0r the power cord to fit through. ::::::::i Attach the plate to the wall using toggle bolts. -
Page 17: Mount The Oven
Installation Instructions i'ei//ove (;enfly tile wires fl'(nn tile Reroute Place the blower unit back into tile oi)ening,. gi'oox the wires through grooxes on other side of the blower unit. AFTER: Fan Blade Openings Facing Back Before Rerouting After Rerouting EndB._>- CAUTION: Do not pull or stretch the blower... - Page 18 Installation Instructions Cabinet Front MOUNT THE OVEN (cont.) Cabinet Bottom Shelf Filler Block NOTE: When mounting the oven, thread power cord through hole in bottom ot top cabinet. Kee I) it quivalent to Depth fight throughout Steps 1-3. of Cabinet Do not pinch cord or lift oven Jfi oven, tilt it Recess...
-
Page 19: [] Recirculafing
Installation Instructions RECIRCULATING (Non-Vented Ductless) INSTALLATION OVERVIEW C1. Mmch Mounting Plate to _4"dl Prepare Top Cabinet C3. A(!iust Blower C4. Mount the (-)\'en Install Charcoal Filter NOTE: Befi)re tightening toggle bolts and wood scre_; ]-€-_ ATTACH THE MOUNTING make sure the tabs on the mounting plate touch the PLATE TO THE WALL bottom... -
Page 20: Blower Fl)R
Installation Instructions _Roll tile blower trait 90 ° so that tim blade openings [-C--_ADAPTING BLOWER FOR are lacing toward tile fl'ont of tile oxen. RECIRCULATION BEFORE: Fan Blade NOTE: Tile exhaust adaptor with damper is not needed tor recirculating models. Y_m mm want to sa_e... -
Page 21: Mount The Oven
Installation Instructions Secure blower unit to oxen with the screw remoxed NOTE: X,_q_enmotmting the oven, in Step 2. thread power cord through hole in bottom of top cabinet. Kee I) it F7] Replace blower plate with the screws remoxed tight throughout Steps 1-3. -
Page 22: Installing The Charcoal
Installation Instructions I-€--_ MOUNT THE OVEN (cont.) VC--_INSTALLING THE CHARCOAL FILTER Cabinet Front Cabinet Bottom Shelf Remo'_e 2 ,_ci'ews on top of grille using a Phillips Filler Block screwdriver: You may need to open cabinet doo_s i'eillo&e scI'ews, quivalent Open dora: to Depth grille. -
Page 23: Before You Use Your Oven
Installation Instructions BEFORE YOU USE YOUR OVEN _Make Stli'e oxen has been installed according Read the Owner's Manual. instructions. KEEP INSTAI,LATION INSTRUCTIONS FOR THE I [] Remo_e all packing material fl'om the o_en. I,OCAI, INSPECTOR _ USE. I [] Install o_en rack (mrntnble) in cavity. - Page 24 164D3370P269 49-40339-1 3828W5U0315 Printed in Korea o7-o3JR...