[] Recirculafing; General Information Attach Mounting Plate To Wall; Preparation Of Top Cabinet - GE SCB1000 Installation Instructions Manual

Installation Instructions
RECIRCULATING
(Non-Vented Ductless)
INSTALLATION OVERVIEW
C1. Mmch Mounting Plate to _4"dl
C2. Prepare Top Cabinet
C3. A(!iust Blower
C4. Mount the (-)\'en
C5. Install Charcoal Filter
]-€-_ ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts. At least one
wood screw must be used to attach the plate to a wall stud.
[_ Remoxe the toggle wings fl'om the bolts.
_] Insert the bolts into the mounting plate through the
holes designated to go into drywall, and reattach the
toggle wings to 3/4" onto each bolt.
To use toggle bolts:
Spacingfor TogglesMore
+]_--_]_._Than Wall Thickness
= Toggle
Wings
Mounting---_
Plate
Bolt
Wall
_] Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Befi)re tightening toggle bolts and wood scre_;
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the wall
and that the plate is properly centered under the cabinet.
CAUTION:
)inchinotinge,s
between the back ot the mounting plate and the wall.
_] Tighten all bolts. Pull the plate awa) fl'om the wall
to help tighten the bolts.
]-€--_ USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to (h_ll holes fin" the top support
screws and a
hole large enough fin" the power cord to fit throu ,h
" Read the instrucdons on the TOP CABINET
TEMPI ATE.
• Tape it underneath the top cabinet.
• Drill the holes, tollowing the instructions on the TOP
CABINET TEMPLATE.
CAUTION:
holes in the cabinet bottom.