Attach Mounting Plate To X_Hll; Preparation Of Top Cabinet - GE SCB1000 Installation Instructions Manual

Installation Instructions
FB--_ATTACH THE MOUNTING
PLATE TO THE WALL
i = il
::::::::i
Attach the plate to the wall using toggle bolts. At least one
wood screw must be used to attach the plate to a wall stud.
_ Remme the toggle wings fi'om the bolts.
_] Insert the bolts into the motmting plate through the
holes designated to go into drywall, and reattach the
toggle wings to 3/4" onto each bolt.
To use toggle bolts:
Spacingfor TogglesMore
_*--_-[_,_Than Wall Thickness
= Toggle
Wings
Mounting.-->_
Plate
Bolt
Wall
[_ Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to motmt
the plate.
NOTE: Before tightening toggle bolts and wood scrm_;
make sure the tabs on the mounting plate touch the
bottom oI the cabinet when pushed flush against the wall
and that the plate is properly centered under the cabinet.
CAUTION: Be c .ef.1
pinching
finge_ between the back of the motmfing plate and
the wall.
[4] Tighten all bolts. Pull the plate axvav fl'om the wall
to help tighten the bolts.
16
VB-3-] U SE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
Ym need to drill holes for the top support screws and a
hole large enough t0r the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPI ATE.
• Tape it underneath the top cabinet.
• Drill the holes, tollowing the instructions on the TOP
CABINET TEMPI ATE.
CAUTION: d, .in
holes in the cabinet bottom.
VB--_ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
_ Remove the 3 that hold the blower to
plate
sciews
the o;en. Slide blower plate from under its retaining
flan ,e Remoxe and saxe the screw that holds blower
II/OtoI" to ox, eil.
@_10_er Motor Scre_
%j_ .... _,.--"
[2] Carefiflly pull out the blower unit. The wires will
extend en- enough to allow xou to at!just the
bl(mer unit.
BEFORE: Fan Blade
Openings _nd B
Facing Up
EndA-_-_ I