Attach Mounting Plate To Wall - GE JVM1500 Series Installation Instructions Manual

A
RECIRCULATING
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Mount the Oven
A4. When Replacing the Charcoal Filter
NOTE: The exhaust adapter with
damper is not needed for recirculating
models. You may want to save them for
possible future use.
A1 ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud.
1 Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through
2
the holes designated to go into drywall and
reattach the toggle wings to
Installation Instructions
(Non-Vented Ductless)
" onto each bolt.
3 ⁄
4
To use toggle bolts:
Spacing for Toggles
more than wall thickness
Toggle Wings
Mounting
Plate
Wall
Place the mounting plate against the wall and
3
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the
wall and that the plate is properly centered under the
cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
Tighten all bolts. Pull the plate away from the wall
4
to help tighten the bolts.
12
Toggle
Bolt
Bolt End