Escape Key; Hash Key; Star Key - Honeywell Galaxy 3-48C Installation Manual

Keypad Operation (cont'd)

Escape Key

esc

Hash Key

#

Star Key

*
The esc key cancels any modification made to the current option and returns
to the previous option level. Successive pressing of this key returns the user
to the banner display.
The esc key also aborts the setting routine if pressed during the exit time.
The # key is used :
• as a toggle key, which enables or disables the programming features of
the Galaxy options, for example, enabling the OMIT attribute of a zone,
• to give additional information on the programming options, for example
pressing the # key while in option 22=DISPLAY LOG shows details of the
user number, descriptor and keypad used to cancel alarms or unset the
system.
• to activate the Duress and PA outputs; enter a valid user code followed by two
presses of the # key, then the ent key to activate the duress alarm.
The key is used:
• to correct or erase PINs in the CODES option and alpha-numeric
descriptors in the TEXT option,
• to start printing from the current event when viewing option
22=DISPLAY LOG.
• to display the set status of the groups. When Show Status (refer to option
58.6=KEYPADS.Show Status) is enabled, pressing the
when the normal banner is displayed indicates the group set status.
R = Ready to Set (all active zones in group closed)
F = Faulted (at least one of the active zones in the group is open)
S = Set
P = Part Set
L = Locked Out
- = Group not assigned to keypad
Note: The Show Status indicates the set conditions of groups when the system is set
(keypad blank) or unset (normal banner). Show Status does not operate while
engineer mode is accessed.
Pressing the and # keys again toggles the display to show the status of the groups
individually. To move between each groups, press the
simultaneously.
Pressing the and # again returns the keypad to the banner display.
Galaxy 3 Series Installation Manual
4-6
and # keys simultaneously
and A or the and B keys