Section 1: Quick Setup - Honeywell Galaxy 3-48C Installation Manual

Galaxy 3 Series Installation Manual

Section 1: Quick Setup

To quickly set up a Galaxy 3 Series control panel for programming follow these simple steps:
1. Connect a 1k Ω (1%) resistor across each of the zones on the panel and any RIO's (if connected).
2. Ensure that the tamper return loop — the terminal marked as
loop.
NOTE: This is factory set as a completed loop with a 0 V return.
3. Connect one of the keypads to the AB LINE terminals on the control panel. The Galaxy 3-48 has
one AB line; the Galaxy 3-144 has two AB lines; the Galaxy 3-520 has four AB lines (when an
RS485 Expansion Module is fitted).
NOTE: G3-48 - There is one AB LINE terminal on the control panel PCB.
NOTE: G3-144/G3-520 - There are two AB LINE terminals on the control panel PCB.
4. Connect a 680 Ω End Of Line (EOL) resistor across the A and B terminals of the keypad.
5. Ensure that the keypad is fitted to the wall (see Keypad Installation Procedure, Section 4).
6. Connect the battery before replacing the control panel lid.
7. Connect the mains wiring to the control panel. Do not switch the mains ON.
8. Replace the control panel lid and secure the fastening screws.
9. Switch on the mains voltage (230 Va.c. / 50 Hz).
10. The following sequence of events occur:
• the keypad buzzer and control panel horn (if fitted) activate for 10 - 20 seconds,
• flashing
• the sounders stop and the keypad displays become blank,
• the green power LED lights and the following displays on the keypad
• the default banner is then displayed on the keypad.
where: XXX is the panel type
Y.YY is the panel software revision
11. The system is now ready to be programmed. Refer to Galaxy 3 Series Programming Manual:
IP1-0033 for programming details.
C o n r t l o P a n l e
L ( n i e ) 1
B 1
A 1
-
+
Table 1-2. Terminal Connections
is displayed on the keypad,
Configuring Configuring Configuring
Configuring Configuring
Please Wait Please Wait Please Wait
Please Wait Please Wait
GALAXY <XXX> <VY.YY> GALAXY <XXX> <VY.YY>
GALAXY <XXX> <VY.YY> GALAXY <XXX> <VY.YY> GALAXY <XXX> <VY.YY>
01:01 01:01 01:01 SUN 01 JAN SUN 01 JAN SUN 01 JAN
01:01 01:01 SUN 01 JAN SUN 01 JAN
1-3
Quick Setup
on the PCB — is a complete
AUX TAMP
K e y p a d
B
A
-
+