Configuring As On-Line Max3 - Honeywell Galaxy 3-48C Installation Manual

Galaxy 3 Series Installation Manual
Configuring a MAX
3
MAX readers can only be configured into the Galaxy system from engineer mode.
Access engineer mode.Wire the MAX
3
The MAX reader must be assigned as either an On-Line or a Stand-Alone module using option 63.2.2 =
OPTIONS.MAX.MAX Address:
0 = On-Line: The MAX
sharing system resources and facilities.
1 = Standalone (default): The MAX operates as an entirely independent unit. The Galaxy does not
3
monitor the MAX for alarms, tampers or power failure.
Configuring as On-Line MAX
1. Connect power to the MAX
2. Ensure that the MAX mode is enabled (option 63.2.1 = OPTIONS.MAX.MAX Mode).
3. Select option 63.2.2 = OPTIONS.MAX.MAX Address and press the ent key; the Galaxy panel
may prompt (depending on model) for the AB line (1 – 4)) that is to be searched; select the line and
press the ent key. The Galaxy searches for the MAX
are addressed as 8 (standalone) by default.
4. Only if adding a new MAX
OPERATING MODE of MAX
NOTE: If reprogramming an existing stand-alone reader, the system automatically selects the On-
Line operating mode.
3
The MAX can then be readdressed. The keypad displays the current address of the MAX
valid addresses. Enter the new MAX
3
dress of the MAX . The keypad indicates the old and new MAX
ming.
3
All new MAX readers default to address 7.
NOTE: It is recommended that when adding a reader, it is addressed as the lowest available number on the
line.
When the reprogramming is complete the MAX
display returns to 2 = MAX Address.
5. Exit engineer mode - engineer code + esc: the keypad displays the message 1 MOD. ADDED -
esc=CONTINUE. LED 2 on the MAX
returns to the unset banner.
If this message is not displayed, the MAX
and has not been configured into the system (LED 2 does not switch on).
NOTES:
3
1. The MAX reader will not operate until engineer mode is exited and the reader is configured into the
system.
3
2. All MAX doors must be closed, otherwise engineer mode cannot be exited.
6. The on-line MAX
3 Reader into the System
3
as per the instructions given in Figures 5-1 or 5-2
3
is fully integrated with the Galaxy system and communicates via the AB line,
3
3
as per Figure 5-1.
3
reader: On locating the MAX
3
to be assigned: select 0 = On-Line and press the ent key.
3
address and press the ent key; the Galaxy then reprograms the ad-
3
3
3
reader is not communicating with the control panel
3
reader is now configured into the system.
Configuring MAX
3
with the highest address. New MAX
3
address, the keypad prompts for the
3
addresses and the status of the reprogram-
bleeps, the LEDs on the MAX
reader switches on. Press the esc key; the keypad
5-3
3
3
readers
3
and the range of
3
switch off and the keypad