Kenmore 911.36665 Owner's Manual page 13

OPERATION
Oven Control, Clock and Timer
Your new control has a series of tones
that will sound at different times These
tones may sound while you set the
control for an oven function, or at the
end of the oven function it wil! a_soalert
you there may be a problem with the
functions. Below are the types of tones
and a brief description of each
TONES WHILE SETTING THE
CONTROL--When you press a touch
pad you will hear a beep This beep wilI
let you know you have placed enough
pressure on the pad to activate it (The
arrow pads do not beep)
END OF TIMED CYCLE TONE--At
the end of an automatic timed cooking
function, you will hear 3 short beeps
followed by 1 beep every 6 seconds
This 6 second beep wil_continue to
sound until the CLEAR/OFF pad is
pressed or you may select lhe special
feature to cancel this 6 second beep
from sounding at the end of future
cycles
TO CANCEL THE 6 SECOND
BEEP
1. Press and hold the BAKE and
BROIL pads, at the same time
for 3 seconds, until the display
shows "SF"
2, Press the KITCHEN TIMER
pad. The display wtll show "CON
HELP" (continous beep)
3. Press the KITCHEN TIMER
pad again, The display will show
"HELP" (beep canceled)
4, Press the START pad to caflcel the
6 second beep and leave the
special feature mode
If you would like to return the 6 second
beep, repeat steps above untif the
display shows your choice and press
Start
ATTENTION TONE--This tone will
sound if you make an error or an
oversight is made while setting an
oven function.
Examples would be:
a. Setting a clean cy(:le and the oven
door is not properly dosed
b. Setting function and not pressing
Start
c, Pressing an additional function pad
without first setting a temperature or
time
d, ERR wil! flash if you set an invalid
temperature Press the CLEAR/OFF
pad to ciear the control and reset
your oven funclion.
Any of these can be quickly identified
by watching the display
PREHEAT TONE--When you set an
oven temperature, the oven automati-
cafly starts to heat When the tempera-
ture inside the oven reaches the tem-
perature you have set, a tone will sound
to let you know the oven is ready for
baking
if you set an oven function and the
control beeps while the display is
flashing "P' and a number or letter
such as "F-4" or "FI" there may be a
problem with the contro! or oven.
Simply press the CLEAR/OFF pad and
wait about an hour. Try setting the
function again. If the code repeats, write
down the flashing cede and call for
service. Telt the technician what code
was flashing
I3
22904020P166 lf2 SIZE 13 10/1./97, 3:16 PM