Table of Contents
Advertisement
SECTION
II1. STRAIGHT
STITCH
SEWING
Straight Stitch
(_ Stitch selector:
1 - 3
Needle thread tension:
2 to 6
Presser foot:
Zigzag foot
II'
I
|
!1'
!
321
_
• Starting to sew
Raise the presser foot and positionthe fabric next to a
seam guide line on the needle plate (5/8" (1.6 cm) is most
common). Lower the needle to the point where you want
to start. Lower the presser foot and pull the threads
toward the back. Depress the foot control. Gently guide
the fabric along a seam guide line letting the fabric feed
naturally.
• Finishing sewing
To fasten the ends of a seam, press the reverse stitch
control and sew several reverse stitches. Raise the
presser foot. Remove the fabric.
Use the Seam Guides
{_) Cornering guide
(_ Guide lines in inches
(_) Guide lines in mi!limeters
The seam guides on the needle plate are there to help you
measure seam width. The numbers on the needle plate
indicate the distance between the center needle position
and the edge of the fabric. The lines are 1;8" (0.3 cm)
apart, and are engraved at 3/8", 4/8", 5/8", and 6/8". The
lines in millimeters are 5 mm apart, and are engraved at 10
ram, 15 mm and 20 mm.
Turn a Square Corner
(_) Cornering guide
When sewing with fabric edge at 5/8" seam guide, in order
to turn a square corner so that sewing continues at the
distance from edge.
1. Stop stitching when the front edge of the fabric reaches
the cornering guide lines.
2. Lower the needle by turning the handwheel
counterclockwise.
3. Raise the presser foot and turn the fabric
counterclockwise 90 °
4. Lower the presser foot and begin stitching in the new
direction.
f"
J
F
3O
Hide quick links:
Advertisement
Table of Contents
