Straight Stitch Sewing; Straight Stitch; Starting To Sew; Finishing Sewing - Kenmore 385.18330 Owner's Manual

SECTION I!1.STRAIGHT STITCH SEWING
Straight Stitch
O Stitch selector:
(_ Stitch width:
_) Stitch length:
(_) Needle thread tension:
_) Presser foot A:
Presser foot H:
6to8
6.5
Red zone
2 to6
Zigzag foot ( I ! I )
!
Straight stitch foot( ,i, only )
NOTE: When using the straight stitch foot, make sure to
set the stitch width controlat 0. Otherwise the needle
may strike the presser foot and possibily break_
• Starting to sew
Raise the presser foot and position the fabric next to a seam
guide line on the needle plate (5/8"(1.6cm) is most common).
Lower the needle to the point where you want to start. Lower the
presser foot and pull the threads toward the back. Depress the
foot control. Gently guide the fabric along a seam guide line letting
the fabric feed naturally.
° Finishing sewing
To fasten the ends of a seam, press the reverse stitch control
and sew several reverse stitches. Raise the presser foot. Remove
the fabric, draw the threads to the back and cut them with the
thread cutter. The threads are cut in a proper length for the next
seam.
, Seam allowance lines
The seam guides on the needle plate and hook cover
plate help you measure seam width°
The numbers on the needle plate indicate the distance
between the middle needle position and the seam
allowance line
r Millimeters
Marks on
needle
15mm 20mm
_. plate
(_ Middle needle position
(_) Edge of fabric
(_) Needle plate guide lines
4/8"
Inches
5/8" 6/8"
J
i i iO
i I i
I I I
_1 D Cl:_¢1)
®
® ®
ou
f
J
J
38