RRP 1-62 Exit Roller Assembly (PL 9.2)
Fig 1-84 Exit Roller Assembly
Removal
1.
Remove the Exit Drive Assembly (RRP 1-55).
2.
Remove the two black machine screws securing the Face Up Lower Chute to
the Assembly frame, and remove the Chute.
3.
Remove the KL-clip securing the Gear located at the rear of the Exit Roller
shaft, and remove the Gear and rear bearing.
4.
Remove the E-ring securing the front of the Exit Roller shaft to the Assembly
frame, and remove the front bearing.
5.
Slide the shaft to the rear, and remove the shaft from the Assembly.
1-250
DocuPrint N4525 Network Laser Printer - Service Guide
Exit Roller
S4525-133