Alpine MDA-W750 Owner's Manual page 84

1
2
3
4
84
CD Shuttle Operation
Multi-Changer Selection
Alpine's Ai-NET system will support up to 6 CD
Shuttles. When operating two or more
changers, the KCA-400C (Multi-Changer
Switching Device) must be used. If you use 1
Switching device, you can connect up to 4 CD
Shuttles. If you use 2 Switching devices, you
can connect up to 6 CD Shuttles.
Press the SOURCE button on the MDA-W750
to activate the CD Shuttle mode.
SOURCE
Alternatively, press the SOURCE button on the
Remote Control (RUE-4185) to activate the CD
Shuttle mode. Proceed to Step 3 below to
select the desired CD Shuttle.
Press the BAND button on the MDA-W750 or
BAND
the RUE-4185 to activate the CD Shuttle
PROG
Selection mode.
The CD Shuttle Selection mode remains active
BAND
for 3 seconds after Step 2 is performed. Press
PROG
the BAND button until the desired CD Shuttle
indicator appears on the display.
Note: If the selected CD Shuttle is not con-
Alternatively press the BAND button on the
Remote control until the desired changer
indicator appears on the display.
To operate the selected changer, see "CD
Operation" section.
2.#
nected, the display will show "NO
CHGRX".
English
1