Usb Board/Wl Holder - Toshiba R600 S4202 - Portege - Core 2 Duo 1.4 GHz Maintenance Manual

4.17 USB board/WL holder

4.17 USB board/WL holder
Removing the USB board/WL holder
To remove the USB board/WL holder, follow the steps below and refer to Figure 4-23 and 4-
24.
1. Open the insulator and take out the RJ45 wire harness from the slot.
2. Disconnect the USB board FPC from the connector CN9610 on the USB board.
3. Open the insulator (HNS HOLD INSULATOR) and disconnect the sensor harness
from the connector CN9620 on the USB board and connector CN9630on the SW
board.
4. Disconnect the camera harness from the connector CN9540 on the USB board.
5. Remove the following screw and USB board.
• M2×3B
Sensor harness
Insulator
USB board FPC
Camera harness
Figure 4-23 Removing the USB board/WL holder (1)
PORTÉGÉ R600 Maintenance Manual (960-709)
S-THIN HEAD
M2x3B S-THIN HEAD
CN9620
Insulator
CN9630
4 Replacement Procedures
×1
RJ45 wire harness
[CONFIDENTIAL]
USB board
Knob
CN9540
CN9610
Slot
4-41