Toshiba R600 S4202 - Portege - Core 2 Duo 1.4 GHz Maintenance Manual page 245

4.6 Memory module
Installing the Memory module
To install the memory module, confirm that the computer is shut down. Then follow the steps
below and refer to Figure 4-5 and 4-6.
CAUTION: When installing the memory module, make sure the computer is powered off.
Inserting a memory module with the power on might damage the module or
the computer itself.
Never press hard or bend a memory module.
1. Insert the memory module into the connector slantwise and press it to connect firmly.
CAUTION: After installing the memory module, make sure that the memory module is
secured with the left and right latches.
2. Install the memory cover and secure it with the screws.
CAUTION: When securing the memory module with the screw, use a "Switch-drive-type
electric screwdriver". Do not use a "Push-drive-type electric screwdriver".
3. When the power of the computer is turned on, the computer checks automatically the
memory size. Confirm that the new memory is detected correctly.
4. If the memory is not detected, check that it is connected correctly.
PORTÉGÉ R600 Maintenance Manual (960-709)
4 Replacement Procedures
[CONFIDENTIAL] 4-17