Toshiba R600 S4202 - Portege - Core 2 Duo 1.4 GHz Maintenance Manual page 271

4.17 USB board/WL holder
Installing the USB board/WL holder
To install the USB board/WL holder, follow the steps below and refer to Figure 4-23 and 4-
24.
1. Set the WL holder in place and fix it with the double-sided tape.
CAUTION: A double-sided tape is stuck to a new WL holder. Wipe off the double-sided
tape stuck on the cover assembly.
2. Set the USB board and secure it with the following screw.
• M2×3B
CAUTION: When installing the USB board, align the switch knob of the USB board to
the slot of the WL holder.
3. Connect the camera harness to the connector CN9540 on the USB board.
4. Connect the sensor harness to the connector CN9620 on the USB board and
connector CN9630on the SW board and close the insulator (HNS HOLD
INSULATOR).
5. Connect the USB board FPC to the connector CN9610 on the USB board.
CAUTION: When arranging the cables, be careful of the following:
6. Set the RJ45 wire harness into the slot.
7. Arrange the RJ45 wire harness and fix it with the insulator.
PORTÉGÉ R600 Maintenance Manual (960-709)
S-THIN HEAD
4 Replacement Procedures
×1
Do not put the cables indicated in
the circle.
[CONFIDENTIAL] 4-43