4 Replacement Procedures
5. Peel off the membrane switch adhered with the double-sided tape and remove the tip
point of the FPC (connector terminal side) from the hole.
6. Peel off the aluminum tape (AL TAPE TPAD) and remove the fingerprint sensor
board adhered with the double-sided tape from the slot.
Aluminum tape
Figure 4-35 Removing the touch pad/fingerprint sensor board (2)
4-60
[CONFIDENTIAL]
4.23 Touch pad/Fingerprint sensor board
Membrane switch
Fingerprint sensor board
PORTÉGÉ R600 Maintenance Manual (960-709)